• General FAQ
• Troubleshooting
• Warranty Registration
• Owner’s Manual
• Warranty Application

#01 - Electric motor does not work.

Overheating of the motor.

These motors are equipped with an internal protector. Wait 10 minutes before using.

#02 - The engine does not start.

a) The emercency button is pushed down.

b) Other reasons.

a) The emergency button must be pulled up to start the engine of the rotary tiller.

b) See the engine's owner's manual.

#03 - Belt showing premature wear.

Spring stretched.

Check spring. Replace if stretched.

#04 - Belt is worn at a specific point.

a) Rotary tiller was engaged when the tines were blocked with debris.

b) Lack of tension on belt.

a) Make sure the tines are not blocked with debris before engaging rotary tiller.

b) Replace the tension spring if it has lost its efficiency.

#05 - Rotary tiller is noisy or bouncing at the front of the vehicle.

a) Tines are damaged or too many rocks.

b) Turnbuckles are loose.

a) replace bent or damaged tines. Remove any rocks from tilling area.

b) Tighten the turn buckles.

#06 - Tiller operates irregularly.

a) Belts are loose.

b) Belts are damaged.

c) A group of tines may be packed up.

a)Tighten belts.

b) Replace belts.

c) Remove any debris from the tines.

Always till at a slow steady speed. Make more than one pass. Start by a shallow pass then gradually deeper. Replace damaged or bent tines.

#07 - Tiller will not turn.

a) Belt is damaged.

b) Belt is broken.

a) Replace the belt.

b) Replace the belt.